Electrical set-up information:

Ensure you have read the operating manual before use and follow all safety instructions

> Power up your high-pressure cleaner
Kranzle pressure washers use industrial grade induction motors and will not run properly on diy type cable reels. Kranzle high-pressure cleaners are supplied with either a 5 or 7.5 metre cable;

If you need to use an extension cable it must have an inner cross section of 2.5mm² cable, this is not the outer cable diameter.

Always fully un-wind any extension cable used - never un-wind only as much as you need

> Final preperations
When you have your gun, lance and hose connected to your machine, a water supply connected, and the electric cable plugged in and in the on position. The "on/off" switch of the machine will start the motor; machines with TS (Total-Stop) facility will turn on in 'standby mode' until you squeeze the trigger gun.

> Electrical thermal overload protection
The On/Off switch has a thermal trip in it to help protect the motor.

If the main on/off switch returns to the 'off' position by itself during use. Allow at least 10 minutes before switching it back on for the machine to cool down.
(Note: High-pressure cleaners with delayed shut-down will automatically turn "off" after a 20-30 minute period of in-activity)

> Fuses in high-pressure cleaners
Kranzle high-pressure cleaners use industrial grade induction motors which may struggle to run properly if used with diy type cable reels, if other electrical equipment is used on the same power source, or the wiring is not of substantial quality.

All Kranzle professional high-pressure cleaners supplied through an approved Kranzle UK supplier are fitted with an 'easy-start', or 'soft-start' feature, dramatically reducing the starting amperage resulting with almost no start-up issues.
*It is possible to retro-fit this feature for older professional models using kit K490411.

> Generator Advice
The wide range of power, intake / out-put figures, kVA, kW and Horse-Power and other variances between even similar generators varies so much.

Exclusively and only owing to feedback of real-life users of our high-pressure cleaners.

Their suggestions are:

The smaller Kranzle portable 7/122 or 7/120 machines require around a 3.5 kW generator;
Most other single-phase Kranzle machines generally require around a 5.5 kW generator.


> Good air ventilation is important!
> Operate only at the maximum or lesser operating pressures of your device!
> Easy-start / soft-start kits can be retro-fitted to existing Kranzle high-pressure cleaners!