Always read the Operating Handbook before use and follow all
Safety Instructions
It is important that your pressure washer has sufficient water and power to run properly. If the pump can not get enough water through it's supply hose damage will occur to the transmission. Always test this by running your hose into a measured container for one minute to make sure there is at least 10% more water flowing from the end of your hose where you will connect it to your machine than the machine's output.
Do not use light weight extension cables. Kranzle pressure washer use
industrial grade induction motors and will not run properly on diy type cable
reels. If you need to use an extension cable it must be a 2.5mm cross
section cable.
If your machine switches itself off while you are using it DO NOT switch it back
on for 10 minutes. The On/Off switch has a thermal trip in it to help
protect the motor. Allow the machine to cool down for at least 10 minutes
before switching it back on. Try to establish why the motor was over
heating. This could be due to inadequate ventilation, use of an inadequate
extension cable or the pump running in excess of it's normal operating pressure
- in which case check the high pressure nozzle on the end of the lance for a
partial blockage and unscrew the unloader hand wheel on the side of the pump
until the pressure shown on the pressure gauge with the trigger squeezed is
correct for your machine.
| Important Safety info re Power Supply & Extention Cables |  184 kb |
| General Safety Information - Please Read | 329 kb |
| Operating Instruction (Preparation for use) K145T | 932 kb |
| Operating Instruction (Preparation for use) K105 | 735 kb |
Problems? Go to Service & Repairs also visit Parts Diagrams
Please email us with your query or call 01702 603462